Image Image

Electrical issue 4jg2

Discuss all things related to 4x4
Post Reply
nzshooter
Posts: 2
Joined: Sun Jan 18, 2015 8:37 pm

Electrical issue 4jg2

Post by nzshooter »

Hey guys my 1994 Isuzu mu, 4jg2 is having some problems. The 3 lights on the dash came on along with the fan/aircon not working which I understand is the relay, due to the alternator overcharging. Truck has been running fine, I have been keeping an eye on the volt meter which only just reaches 16v at high rpm. My intentions were new alternator and relay very soon.

However, lastnite the truck died (very strange) then upon trying to start the glow light would not come on and no click under the bonnet and it just turns over.
I found that the fuse called: 8 engine back. L which is a 15A was blown and continues to blow new fuse when attempting to start. So my guess there is a main relay before this that is shot? Or maby the glow plugs are shot?
Any info greatly appreciated
Cheers
turnturn
Posts: 162
Joined: Sat May 16, 2009 12:46 am

Re: Electrical issue 4jg2

Post by turnturn »

I think that this fuse also controls the fuel shut off solenoid (75% sure).

I recently bought a Mu (not going) for spare parts that this fuse had blown. Turned out that during a recent clutch repair the wiring loom running over the back of the motor (fuel shut off, rev counter etc) had been pinched between the bell housing and the engine.

When I was playing around trying to get it going it gave similar symtoms to your description above (second paragraph). I ended up hot wiring it (wire/fuse/switch to fuel cut off solenoid).

Has any other work been done to your vehicle lately? The problem that I have described above took a couple of weeks to happen for the previous owner.
nzshooter
Posts: 2
Joined: Sun Jan 18, 2015 8:37 pm

Re: Electrical issue 4jg2

Post by nzshooter »

Cheers for the reply. No other work has been done recently other than wheel bearings etc, nothing to effect that wire? Hmm it's very strange. I will see if there is any damage to that wire
orion
Posts: 1
Joined: Tue Feb 24, 2015 5:46 am

Re: Electrical issue 4jg2

Post by orion »

Hi there, I had a similar question...

I had the glow plug timer not working well, and the mechanic disconnected the temperature sensor. It was hard to start when hot because the glow plugs wouldn't stay on long enough.

When i got the car back it would overcharge the battery and get past 16V on the dash gauge past 2.5k revs. The auto transmission also wouldn't go into 4th. The transmission problem they related back to the temp sensor on the glow timer.
I also ended up having to fork out for a new alternator.

would having the temp sensor fail or removed cause the over-voltage and stuff up the alternator? does anyone have a circuit diagram or can point me in the right direction?
User avatar
geeves
Posts: 1981
Joined: Mon May 11, 2009 1:56 am

Re: Electrical issue 4jg2

Post by geeves »

4th gear quite possibly but alternator no. When a 4jg2 is warm it doesnt need glow plugs.
Post Reply